Split roller bearing SPL series

Giá: Liên Hệ

Introduction
Comfortable rectification from spherical bearing

Solid spherical bearings are normally used together with split SN, SD plummer block. Block are split, therefore easy assembly expected, nevertheless fitting and dismantling solid
Bearings are very difficult and take long time. (you have to remove all of the neighborhood parts.) SPL series split bearing con be fitted in existing plummer block, in place of spherical
Bearing, without any modification.

Note: for locating position BR type is applied, whereas BX type should be ordered for floating position

Special features
  • Every main component has two halves.
  • Outer ring and inner ring has angled joints to ensure continuity of contact with rollers.
  • Two halves of inner ring are fully fitted on shaft by two clamping rings
  • When fitting two halves of inner ring on shaft, there should be a gap at the joint in order to ensure full contact between the bore of inner ring and shaft. The gaps differ from the sizes, 0.35mm to 0.55mm
  • We use auto-locking cage, made of aluminum or brass steel clips attached in each halves of cage enable self-locking.
  • For fitting in misalignment positions, blocks are separated into two parts, housing and support. The joint surface between housing and support are rounded in order for self ailgning

Sản Phẩm Thường Được Xem Cùng